- This topic has 6 replies, 2 voices, and was last updated 1 week, 5 days ago by
.
-
Posts
-
Curt,
Since I did a full upgrade to 28.00-01 note! full upgrade (back to Factory) have not had anymore problems. Even upgraded to 32Gb Ram.
Have noticed that the internal speakers are now on Line out 1 leaving me to connect my speakers to Line out 2 – This is the reverse to how it was before rebuild, in the out mixer line out 1 was line out 2 on the back panel and line out 2 was line out 1. Which is how I want it. But just for interest do you know where I can change if needed?
The Anti-virus Pop-ups have gone away but I did notice the defender updated when I was connected to internet for about 5 minutes. See Attached Pictures.Regards,
Derek……..Derek – Good news on the update results. I did notice in an earlier post you commented that your outputs were “backward.” At the time, I almost commented that I had not seen that.
Now I’m not telling you to change anything,
- but I am aware of a configuration file, and when looking through it, look what I found:
[AudioDevices]
LineOut2=2
LineOut1=1
WinIn=3
HPOut=7
MicIn=2
LineIn=0
Mic1Volume=8Hi Curt,
That’s good news I like it as is, so no intention of changing.
Well worth resetting back to factory and starting afresh than finding it’s wrong
further down the line.Also the Roland Integra 7 is fully installed and working well.
Only the Screen to change when Wersi delivers.
Now I can get on and start playing the beast…..
Regards,
Derek……Hi Curt,
That may explain the error message that kept pop-in up on start up.
Funny it does not pop-up anymore……see attached.
Regards,
Derek…….Hi Curt,
Sorry back again – the Audio Board error is still pop-in up on the odd occasion.
Have to restart to clear have you any idea’s etc???
Derek…..
I have no idea other than since it’s intermittent, possibly a loose connection? Perhaps reseat all the cables inside and see if it clears up?
- You must be logged in to reply to this topic.